The only way to do that in SW would be to add the dimensions as ordinate, then link them into a note. Hide the original ordinate dimensions. If you need to do a lot of this, you'll probably need to come up with a macro to automate the process.
Dimensioning X,Y Coordinates in Drawings?
Aug 30, 2004
2 Replies
Is there a way to dimension X, Y coordinates in a drawing view based on a user picked 0,0?
Example would be a composite of horizontal ordinate dimension and vertical ordinate dimension on one callout.
X=2" Y=3 1/2"
Thanks.
How about a Hole Table? Best Regards, Devon T. Sowell
formatting link
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required