Hatching Ribs in a section view (of a part)

In a drawing of a part, if a section line passes through a rib (or web) it is not normally shown with hatch lines in the section view. Is there any way of preventing this from happening in Solidworks? If you section the drawing of an assembly you can use the Section Scope tab on View Properties to NOT hatch a selected part.... is it possible to do this when sectioning a part on the drawing of that part... ie select a feature (ie rib) that is not to be hatched by the section line???


Mike P

Reply to
Mike P
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.