It appears that when I place a drawing view of a mirrored part (the mirror, not the original), there are no model dimensions available (and holes are 'dumb'). Is this what you all see? Is there perhaps a setting that tells SW to bring dimensions over into mirrored parts? Fingers crossed...
If you are using SW 2005, you might want to try the new "automatic dimension" tool in your drawing. While they are not driving dims, they should suffice from a documentation standpoint.
What information are we missing here? Or, better, what are you trying to do? It is assumed that if you are "mirroring" you already have a fully defined sketch, correct? When you mirror, all dimensions are "mirrored" as well, even though they do not show. If you change one of the master dimensions, the mirrored side updates as well. Now, if you want to change the mirrored side INDEPENDANTLY of the original sketch, you will have to break the existing relations. At this point, the broken relations lines will turn blue. You can then dimension these as you like. Of course, your part is no longer symmetrical at this point.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here.
All logos and trade names are the property of their respective owners.