How do you delete a simulation that doesn't show up in the feature manager? There are no errors in the assembly however when I open a the drawing of the assembly there appears a red cherry on the drawing view in the feature manager. When I RMB on the view and pick "What's Wrong" it says: "Simulation: This feature had an error in the last update. Edit definition on the feature to correct the problem."
Any Ideas how to delete something that isn't there?
Different configurations in assy and drawing ? or is maybe the simulation in a subassy ?
Krister L
"JF" skrev i meddelandet news:9zAdd.6243$5l3.5152@trnddc02...
I noticed with Animator in 2004 if you assigned animations to flexible sub assemblies sometimes those animations would just disappear(seemed that they would intermittently become un-expandable, It never caused a drawing call an error like that though.
Corey
The assembly has no configurations and it's not a sub assy. of another assy. The original assy did have a simulation at one point in time but I deleted it. Another point I'd like to make is while in the assembly mode, the simulation icon "PLAY" was lit up?!? The drawing has 4 views of 4 different assy's on it.
I say "was" because I shut down SW and shutdown the computer turned it back on started SW back up loaded the assy's and drawing and there were gone! ???
SolidWorks 2004 SP 4.2
Have something to add? Share your thoughts — no account required.
Ask the community — no account required