1. Home
  2. Solidworks CAD Design software
  3. SW 2004 Issues...

SW 2004 Issues...

We just installed 2004 this morning and have found a couple problems.

  1. Printing - We get 2 prints of everything we send to the printer. This happens on all of our pc's that are running SW 2004.

  1. Materials - If there are materials assigned to a part, you cannot make the part transparent in an assembly.

Thanks,

DT

Reply to
Derek Taylor
Loading thread data ...

Saw the same thing here from one of three seats. I looked at the printer settings, changed nothing and tried again. Now only one print. Go figure.

Dave H

Reply to
Dave H

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.