Adding X to drawing view

I am trying to detail a drawing view of an assembly. There is a long
seam between two of the parts. I am trying to put a "X" at 1", 16",
28", and 41" to indicate spot welds. Is there a way to do this and
have the "X"s move if I move the view?
Thanks,
Brian
Reply to
Brian
Loading thread data ...
Datum targets can be attached to points, but it can be tricky getting them to attach the way you want.
To make entities "stick" to a view, right-click the view and select "Set view focus" before creating the entities.
Reply to
That70sTick
RMB on the view and expand the menu there will be the option to Lock View Focus. Once the focus is locked you are drawing on the view and everything will move with the view. You could also accomplish this by sketching it in the model and extruding surfaces Then to get the surfaces to show in the drawing you Insert>Model Items>Surfaces. Or without surfaces you could just show the sketch in the desired views.
Regards,
Corey
Reply to
CS
Reply to
jtchambliss
Thanks for the help. I'm going with sketching in the assembly, then showing the sketch in the view. The "view focus" tip will come in handy too.
Reply to
Brian

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.