1. Home
  2. ⚙ Stationary Engines - UK
  3. Further with the Trolley for the L

Further with the Trolley for the L

Gentlemen,

Today having put a new wire feeder on my welder the seagulls have departed, so it wasn't operator error :-)), I have managed to get the Lister L trolley all but finished except for a coat of paint. Is it strong enough, I hope so, its heavy enough.

Also tinkered with the M managed to move one of the valves and found only gunged up and not seized, that was after I managed to snap a 5/16 screw driver blade in half trying to undo the plug. Removed the inspection cover to look in side and apart from black treacle its in very good nick. All of the nuts and bolts with the exception of those in the area of the Vaporiser are free to undo. Hopefully next Sunday I will remove the Mag and see if there is life.

Pictures in usual place.

Martin P

Reply to
Campingstoveman
Loading thread data ...

Only thing that would reach down into plug hole, but then switched on brain and used a socket on other end.:-))

Mart> Camp>>

Reply to
Campingstoveman

Just can't throw those tube spanners away, eh? :-))

Tom

Reply to
Tom

Know what you mean I pulled the plugs on my SP250 engine at the WE, without a magnet in the socket, it's quite a trick to extract the plugs from so deep a hole.

Tom

Reply to
Tom

My plug spanner is a bit like me: losing it's grip, some would say.. :-(

Tom

Reply to
Tom

Martin, Thank you for that tip, its a good job everything I do is perfect, just ask my wife, so the trolley will be perfectly square :-))

Mart> Martin, good job done on the trolley. If you don`t mind I would like

Reply to
Campingstoveman

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.