1. Home
  2. Solidworks CAD Design software
  3. PROBLEM Component Line Font

PROBLEM Component Line Font

I have an assembly with...kill...multiple instances of a sub-assembly. The problem is one of the instances is optional (the assembly is a kit) so I want to...kill...show it in Phantom. Select the correct....kill.....sub and select component line font and change it to Phantom. What happens is in the view the wrong...kill...component is shown Phantom. Or half of the parts in one...kill...instance of the sub assembly and half of the other are phantom. Has anyone run into this problem, and if you have is there a workaround this is dirving me to the funny farm.

Corey Scheich adjfalkjdf;alkjgaspoigupojgaj Frustration Manager Garlock Equipment

Reply to
Corey Scheich
Loading thread data ...

I have done this using Alternate Position Views.

Look for this thread: Transparent parts in drawing files

and my reply. I think I took the example files off of the web, so let me know if you want to see them.

Reply to
Arlin

Which SP are you at? I know some line font issues were fixed in SP4.

Reply to
Devlin

Well I had sent it to my VAR and he tested in 2004 and SP4.0 of 2003 and same results.

Reply to
Corey Scheich

Corey This is not a new problem...I've seen it through a few of the versions of SW...first time I noticed it was in 2001....but it could have been there before. What I did was tro remove the view and put it back in again.

Krister

Corey Scheich skrev i diskussionsgruppsmeddelandet:bjajbe$h7i27$ snipped-for-privacy@ID-200385.news.uni-berlin.de...

Reply to
Krister L

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.