SW2008-Views mixed up in 3rd angle projection

It appears that SW is working in 1st angle even though it is set to

3rd angle.

I created a drawing using the back view as the first view. I then projected a top, bottom and right view. The problem is that the views are backwards as they would be in a 1st angle projection. SW is set to

3rd angle projection.

The assembly is set to 3rd angle, but started life in the iso standard and then was changed to the iso standard.

Has anybody else seen this?


Reply to
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.